Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Note d'installation - Page 12

Parcourez en ligne ou téléchargez le pdf Note d'installation pour {nom_de_la_catégorie} Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 28 pages. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Également pour Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion : Note d'installation (14 pages), Manuel de solution (17 pages), Note d'installation (46 pages), Livre blanc (19 pages), Description (1 pages), Bulletin d'information sur les produits (6 pages), Avis (4 pages), Fiche technique (9 pages), Fiche technique (18 pages), Livre blanc (18 pages), Manuel de configuration (8 pages), Manuel de dépannage (11 pages), Note d'installation (18 pages), Manuel de l'utilisateur (17 pages), Note d'installation (24 pages), Manuel (19 pages), Note d'installation (36 pages)

Installing the CSM

Required Tools

These tools are required to install the CSM in the Catalyst 6500 series switches:

•

Whenever you handle the CSM, always use a wrist strap or other grounding device to prevent

electrostatic discharge (ESD).

Caution

During this procedure, wear grounding wrist straps to avoid ESD damage to the module. Do not directly

touch the backplane with your hand or any metal tool, or you could shock yourself.

All Catalyst 6500 series switches support hot swapping, which allows you to install, remove, replace,

and rearrange modules without turning off the system power. For more information on removing the

CSM from a switch, see the

When the system detects that a module has been installed or removed, the system automatically runs

diagnostic and discovery routines, acknowledges the presence or absence of the module, and resumes

system operation.

These sections describe how to install and verify the operation of the CSM in the Catalyst 6500 series

switches:

•

Slot Assignments

The Catalyst 6006 and 6506 switch chassis have 6 slots, the Catalyst 6009 and 6509 switch chassis have

9 slots, and the Catalyst 6513 switch chassis has 13 slots.

The Catalyst 6509-NEB switch has vertical slots, which are numbered 1 to 9 from right to left. Install

Note

the modules with the component side facing to the right.

•

Catalyst 6500 Series Switch Content Switching Module Installation Note

Flat-blade screwdriver

Phillips-head screwdriver

Wrist strap or other grounding device

Antistatic mat or antistatic foam

"Removing the Module" section on page

Slot Assignments, page 12

Removing the Module, page 13

Installing a Module, page 14

Slot 1 is reserved for the supervisor engine.

Slot 2 can be used for a redundant supervisor engine if the supervisor engine in slot 1 fails.

If a redundant supervisor engine is not required, slots 2 through 6 on the 6-slot chassis, slots 2

through 9 on the 9-slot chassis, and slots 2 through 13 on the 13-slot chassis are available for

switching modules, such as the CSM.

The empty slots require filler plates, which are blank switching-module carriers that maintain

consistent airflow through the switch chassis.

13.

78-15751-03