Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Manuel - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 19 pages. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Également pour Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion : Note d'installation (14 pages), Manuel de solution (17 pages), Note d'installation (46 pages), Livre blanc (19 pages), Description (1 pages), Bulletin d'information sur les produits (6 pages), Avis (4 pages), Fiche technique (9 pages), Fiche technique (18 pages), Livre blanc (18 pages), Manuel de configuration (8 pages), Note d'installation (28 pages), Manuel de dépannage (11 pages), Note d'installation (18 pages), Manuel de l'utilisateur (17 pages), Note d'installation (24 pages), Note d'installation (36 pages)

Imprimer la page
Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Manuel
Cisco - Connecting a Terminal to the Console Port on Catalyst Switches

Console Port Mode Switch

The console port mode switch allows you to connect either a terminal (DTE) or a modem (DCE)
depending on the mode that is selected and the cable that you are using.
Note: The cable and adapters shipped with the Supervisor Module II G and Supervisor Module III G are
the same ones used on the Cisco 2500 series routers (and other Cisco products).
Use the console port mode switch as follows:
Mode 1: Press to the in position. Use this mode to connect a terminal to the port using the console
cable and DTE adapter (labeled "Terminal") that shipped with the Supervisor Engine. You may
also use this mode to connect a modem to the port using the console cable and the DCE adapter
(labeled "Modem") that shipped with the switch.
Mode 2: Depress to the out position. Use this mode to connect a terminal to the port using the
Supervisor Engine III console cable (not provided).
Figure: EIA/TIA-232 RJ-45 Adapter Cable Connector
Table F-1: Console Port Signaling and Cabling Using a DB9 Adapter
Switch
RJ45-RJ45
Console
Rollover Cable
(DTE)
RJ45
Signal
Pin
RTS
1¹
DTR
2
TxD
3
GND
4
GND
5
RxD
6
DSR
7
CTS
8¹
¹Pin 1 is connected internally to Pin 8.
Table F-2: Console Port Signaling and Cabling Using a DB25 Adapter
http://www.cisco.com/warp/public/473/9.html (12 of 19) [9/4/2003 12:36:03 PM]
RJ45-to-DB9
Adapter
RJ45
DB9 Pin
Pin
8
8
7
6
6
2
5
5
4
5
3
3
2
4
1
7
Terminal
(DTE)
Signal
CTS
DSR
RxD
GND
GND
TxD
DTR
RTS