Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Note d'installation - Page 26

Parcourez en ligne ou téléchargez le pdf Note d'installation pour {nom_de_la_catégorie} Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 36 pages. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Également pour Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion : Note d'installation (14 pages), Manuel de solution (17 pages), Note d'installation (46 pages), Livre blanc (19 pages), Description (1 pages), Bulletin d'information sur les produits (6 pages), Avis (4 pages), Fiche technique (9 pages), Fiche technique (18 pages), Livre blanc (18 pages), Manuel de configuration (8 pages), Note d'installation (28 pages), Manuel de dépannage (11 pages), Note d'installation (18 pages), Manuel de l'utilisateur (17 pages), Note d'installation (24 pages), Manuel (19 pages)

Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Note d'installation
Installing a DFC4 Daughter Card
Figure 16
Use a Phillips-head screwdriver to install the installation hardware:
Step 6
For the DFC4-A and the DFC4-AXL daughter cards, install the 9 screws and the 2 standoffs. (See
a.
Figure
For the DFC4-E and the DFC4-EXL daughter cards, install the 6 screws, 2 cap nuts, and 1 standoff.
b.
(See
You must install all of the installation hardware. The screws provide grounding between the DFC4
Caution
daughter card and the Ethernet module. Failure to install all of the screws will invalidate the safety
approvals and create a risk of fire and electrical hazard.
Note
Catalyst 6500 Series Distributed Forwarding Card 4 for WS-X68xx, WS-X69xx, and Select WS-X67xx Modules Installation Note
26
Seating the DFC4 Daughter Card on the Module
WS-X5530
17.)
Figure
18.)
You should visually verify that there are standoffs beneath the mounting holes before installing
the installation hardware.
Apply pressure to bracket.
to seat DFC connectors.
Do not press on heat sinks.
OL-24918-02