Cisco 9124 - mds multilayer fabric switch Manuel d'installation du matériel - Page 18

Parcourez en ligne ou téléchargez le pdf Manuel d'installation du matériel pour {nom_de_la_catégorie} Cisco 9124 - mds multilayer fabric switch. Cisco 9124 - mds multilayer fabric switch 36 pages. Mds 9000 series
Également pour Cisco 9124 - mds multilayer fabric switch : Spécifications (2 pages), Fiche technique (9 pages), Spécifications (3 pages), Manuel de configuration (49 pages), Note de mise à jour (48 pages), Note de mise à jour (44 pages), Note de mise à jour (36 pages), Note de mise à jour (22 pages), Note de mise à jour (3 pages), Note de mise à jour (40 pages), Manuel (16 pages)

Installing the Switch in a Cabinet with Insufficient Front Clearance

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Note

Route the power cord through the open cutout at the end of one of the slider rails, and then let the

cord dangle while you proceed with the next steps.

through the open cutout in the slider rail.

Position one of the slider rails against the front rack-mounting rails and align the screw holes as

shown in

the rack rail thread type. For racks with square holes, first install the 12-24 cage nuts.

Repeat with the other slider rail on the other front side of the rack.

Use the tape measure and level to verify that the rails are horizontal and at the same height.

Figure 2-13

Cisco MDS 9100 Series Hardware Installation Guide

2-18

When installing the Cisco MDS 9148 Switch, Cisco MDS 9134 Switch or the Cisco MDS 9124

Switch rear-facing into a cabinet, do not install it higher than RU-30.

Figure

2-13. Then attach them using two 12-24 screws or two 10-32 screws, depending on

Installing the Notched Slider Rails to the Front Rack-Mounting Rails

Chapter 2

Installing the Cisco MDS 9100 Series

Figure 2-15

shows a power cord correctly routed

OL-21514-01