Bymat Brushline 1150 RS Manuel de l'utilisateur - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Bymat Brushline 1150 RS. Bymat Brushline 1150 RS 12 pages.

Imprimer la page

User manual Bymat 1130 RS

The Bymat 1130 RS machines are designed to be used for the cleaning and polishing of stainless steel

welds and the embossing of stainless steel and other conductive materials.

All persons using this equipment should familiarize themselves with these instructions before using the

equipment.

Before using this equipment please check:

The mains cable is in good condition and is undamaged. The mains plug is securely fitted.

The red and black cleaning leads are in a good condition. The brush / anode is in good

condition. The area to be cleaned is free from oil and dirt etc

Prior to use:

Connect the machine to the mains power supply but leave the machine switched off.

NOTE: After switch off please wait min. 1 minute before restarting the machine.

Connect one end of the black cable to the black socket on the front of the machine

Connect the other end of the black cable to the brush / anode

Connect the end of the earth cable to the red rounded socket on the front of the machine

Connect the earth clamp to the workpiece

WARNING

Under NO circumstances should the solutions be swallowed.

Should the solutions come into contact with the eyes wash immediately with

copiousamounts of clean water

Cleaning

Switch the machine on by means of the switch located on the back of the machine

Turn the 3 position switch on the front of the machine to position number 1: 10,5 volts will be

displayed in the display also located on the front of the machine.

The brush is connected using the accompanying black cable to the black connector

of the machine.

Select the cleaning solution required for the weld area to be cleaned

(Electrolyte A / B / C / C Plus or LF), shake the solution vigorously and pour the required

amount into the wide mouth container.

Attach the earth clip to the part to be cleaned

Dip the brush complete with the carbon fiber in the wide-necked container until the fiber is

complete soaked.

Gently stroke the brush over the weld area, the electrolytic process will clean the weld.

After cleaning with a spray bottle, spray Neutralyt onto the cleaned area.

Then wipe off with plenty of water.

During prolonged use the brush may become hot, simply disconnect it from the cable and

cool in a bucket of water or under a tap, dry the brush, replace the brush tip and reconnect

to the black cable, or use another brush.

CAUTION

To avoid short circuiting the machine, change the brush end before all the brush fibers are

depleted. Whilst using chemicals an acid resistant apron, gloves and suitable eye

protection should be worn. Avoid getting solutions on your skin, if you do get the

solutions on your skin, rinse off with plenty of clean water. Low alloy steels, residual

cooling liquid, drilling oil and similar substances can result in chemical reactions.