Cisco AP776A - Nexus Converged Network Switch 5020 Note de mise à jour - Page 15

Parcourez en ligne ou téléchargez le pdf Note de mise à jour pour {nom_de_la_catégorie} Cisco AP776A - Nexus Converged Network Switch 5020. Cisco AP776A - Nexus Converged Network Switch 5020 22 pages. Cisco nexus 5000 series release notes release 4.1(3)n1(1) (ol-16601-01 h0, july 2009)
Également pour Cisco AP776A - Nexus Converged Network Switch 5020 : Note de mise à jour (48 pages), Note de mise à jour (44 pages), Note de mise à jour (26 pages), Manuel de référence rapide (14 pages), Note de mise à jour (3 pages), Note de mise à jour (26 pages)

Imprimer la page
Cisco AP776A - Nexus Converged Network Switch 5020 Note de mise à jour
FC AND FCIP WRITE ACCELERATION FEATURE MUST NOT BE
ENABLED WHEN IMPLEMENTING CONTINUOUS ACCESS
ENTERPRISE VIRTUAL ARRAY
Continuous Access Enterprise Virtual Array includes an FC/FCIP write acceleration feature. For
this reason, Cisco's FC and FCIP write acceleration must not be enabled in a Continuous Access
EVA environment. By default Cisco SAN-OS write acceleration is disabled.

FCIP TAPE ACCELERATION

SAN-OS FCIP Tape Acceleration (Write & Read) is disabled by default. Enabling FCIP Tape
Acceleration may cause a tape library to go offline with certain tape backup applications that
support shared tape library options. If this issue is encountered, disable the feature.
Note: FCIP Tape Read Acceleration can only be enabled when both ends of the FCIP tunnel are
running SAN-OS 3.0(1) or newer
SWITCH SETTINGS FOR HP CONTINUOUS ACCESS
ENTERPRISE VIRTUAL ARRAYS AND HP DATA REPLICATION
MANAGER FOR MODULAR ARRAYS
The default load balancing policy for SAN-OS is Src-ID/Dst-ID/OX-ID. This must be changed
when using Enterprise Virtual Array families or Modular Array families configured for
Continuous Access EVA and/or Data Replication Manager (DRM). Change the default load
balance setting to Src-ID/Dst-ID using either one of the following two procedures:
Note: The MDS 9020 only supports Src-ID/Dst-ID.
Using the Management Console or Telnet to Change the Load Balancing Setting
Use the following procedure to change the load balance setting to Src-ID/Dst-ID with
management console or telnet:
Note: Your login account must have network-admin privileges to complete this procedure.
1. Log into the switch using either the management console or telnet.
2. Enter your network-admin privileged account by entering your login name and password.
switch login: admin
Password: <admin password>
3. Enter the following to enter configuration mode:
15
MDS Multilayer Director & Multilayer Fabric Switches Release Notes