Accustic Arts AMP I MK 2 Manuel - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Accustic Arts AMP I MK 2. Accustic Arts AMP I MK 2 10 pages.
Également pour Accustic Arts AMP I MK 2 : Manuel (14 pages)

Imprimer la page
Accustic Arts AMP I MK 2 Manuel
6.1 Description of function
The red LED 6 signals that the output relay of the right output stage channel is open and that means
that the transmission of a music signal to the connected loudspeaker is interrupted.
The blue LED 7 in the middle signals that the unit is switched on (operational status).
The red LED 8 signals that the output relay of the left output stage channel is open and that means
that the transmission of a music signal to the connected loudspeaker is interrupted.
By pressing the mains power switch 3 on the rear side of the unit you connect the unit to the mains
power. After the switch is operated all three LEDs firstly light up. After approx. 5 seconds both red
LED's go out while the blue LED 7 indicates the operational status.
6.2 How to start the power amplifier
The unit can be switched on by pressing the mains power switch 3 on the rear panel.
1.
2.
After switching on the mains power-on/off switch all three LEDs will turn on. After approx. 5
seconds ("protection") the two red ones will extinguish, while the blue LED 8 stays on showing
that the unit is running.
IMPORTANT!
Switching on: Always switch on the power amplifier last, i.e. after the other
devices in your system (preamplifier, CD player, etc).
Switching off: Always switch off the power amplifier first and then switch off the
other devices from the mains power.
IMPORTANT!
After switching the unit off please wait 30 seconds before switching it on
again.
Avoid unnecessarily frequent switching the power amplifier on and off. The high
amount of switch-on current is a heavy burden for the electrical components and
so the life of the unit will be shortened by this action.
WARNING!
During a thunderstorm please completely disconnect the unit from the mains
power by pulling out the plug of the mains cable.
7 Looking after your amplifier
This high quality product from ACCUSTIC ARTS
usual care taken with high quality devices. Clean the housing with a dry or slightly moistened cloth.
Please do not use any aggressive detergents or detergents which contain silicon.
The best way to clean the chromed inlay is with a mild non-aggressive fat-dissolving detergent (e.g.
glass cleaner). Use a very soft clean cloth and wipe the front plate with this without exerting strong
pressure. Never use abrasive agents or polishing agents with abrasive particles.
IMPORTANT!
Do not place the unit in direct sunshine and avoid extreme changes in
temperature.
®
does not require special treatment in excess of the
9