Cisco Catalyst 2960-X Manuel d'installation du matériel - Page 31
Parcourez en ligne ou téléchargez le pdf Manuel d'installation du matériel pour {nom_de_la_catégorie} Cisco Catalyst 2960-X. Cisco Catalyst 2960-X 34 pages.
Également pour Cisco Catalyst 2960-X : Manuel de démarrage (25 pages), Manuel du matériel (20 pages)
Imprimer la page
Switch Installation
Connecting to 1000BASE-T SFP
When connecting to a 1000BASE-T device, be sure to use a four twisted-pair, Category 5 or higher cable.
The automatic medium-dependent interface crossover (auto-MDIX) feature is enabled by default. For
Note
configuration information for this feature, see the switch software configuration guide or the switch
command reference on Cisco.com.
Caution
To prevent ESD damage, follow your normal board and component handling procedures.
Procedure
Step 1
Connect one end of the cable to the SFP module port. Insert a four twisted-pair, straight-through cable when
you connect to servers, workstations, and routers. Insert a four twisted-pair, crossover cable when you connect
to switches or repeaters.
Step 2
Connect the other end of the cable to an RJ-45 connector on the other device.
Figure 26: Connecting to a 1000BASE-T SFP Module
1
OL-28309-02
RJ-45 connector
Catalyst 2960-X and 2960-XR Switch Hardware Installation Guide
Connecting to 1000BASE-T SFP
31