Cisco Catalyst 3040 Manuel de démarrage - Page 18

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage pour {nom_de_la_catégorie} Cisco Catalyst 3040. Cisco Catalyst 3040 37 pages. Catalyst blade switch for fsc

Imprimer la page

Step 6

(Optional) Configure Simple Network Management Protocol (SNMP) by responding to

the prompts.

To configure SNMP later, press Return (which applies the default of no). If you accept the

default, you can configure SNMP later through the CLI.

Configure SNMP Network Management? [no]:

To configure SNMP now, enter yes.

Configure SNMP Network Management? [no]: yes

Community string [public]: public

The Current interface summary displays.

Enter vlan1 for the interface name at this prompt:

Step 7

Enter interface name used to connect to the management network from the above

interface summary.

To configure the interface, enter Yes after the prompt, and then enter the blade switch

Step 8

IP address and subnet mask. Press Return.

The IP address and subnet mask shown here are examples:

Configuring interface Vlan1:

Configure IP on this interface? [yes]: Yes

IP address for this interface [10.0.0.1]: 10.0.0.1

Subnet mask for this interface [255.255.255.0] : 255.255.255.0

Class A network is 10.0.0.1, 21 subnet bits; mask is /21

Enter no when the prompt asks you if you would like to enable the blade switch as a cluster

Step 9

command switch. This is a standalone blade switch.

Would you like to enable as a cluster command switch? [yes/no]: no

Note

Clustering is not supported on the Cisco Catalyst Blade Switch 3040 for FSC.

You have now completed the initial configuration. An example of the output is shown here:

The following configuration command script was created:

hostname switch1

enable secret 5 $1$cagJ$e4LP91PNazfdADoNAZm6y0

enable password enable_password

line vty 0 15

password terminal-password

snmp-server community public

interface Vlan1