Crestron 6506188 Manuel de démarrage rapide - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Crestron 6506188. Crestron 6506188 3 pages. Cable retractors for fliptops
Imprimer la page
CBLR Series
2
Adjustments
Once the retractor arm configuration is set, refer to the following illustration and adjust
retractor arm tension and cable retraction speed as follows:
1.
Adjust retractor tension by loosening the top thumb screw enough to enable pulling or
pushing the adjacent cable end to align the red screw with the label arrow.
2.
Adjust cable retraction speed by first pulling the knob outward and moving it to the VERT
or HORZ position to match the configuration of the retractor arms.
a.
Pull the cable (plug end) out so it is fully extended.
b.
Press the retraction lever and observe the speed of the cable retraction. If
it is too slow or too fast, reposition the knob to an intermediate position and recheck.
Adjusting Retractor Tension and Retraction Speed
Red Screw
Thumb Screw
ONCE INSTALLED, USE TOP THUMB
CABLE RETRACTION
SCREW TO ADJUST CABLE LENGTH UNTIL
SPEED ADJUST
RED SCREW IS ALLIGNED WITH ARROW
3
Assembly
Assembly consists of:
•
Attaching the cable retractors to the FlipTop box
•
Attaching the horizontal mounting bracket and
connecting the retractor arms for horizontal orientation
During the following procedures, refer to the accompanying illustrations.
NOTE: For assembly of FlipTop 600 Series models, refer to "Attach Cable Retractors to
the FlipTop (FlipTop 600 Series)" in the third column on this page.
Attach Cable Retractors to the FlipTop (Non-FlipTop 600 Series)
1.
Insert the necks of the retractors and any included spacers up and into the mounting
bracket assembly until they engage the frame of the assembly.
2.
Carefully slide the clevis pin through the hole in the side of the mounting bracket
assembly and through each item being mounted until it protrudes through the opposite
side of the assembly.
3.
Insert the supplied hairpin cotter pin into the hole in the clevis pin to secure it.
4.
Tighten the screws in the neck assemblies so they are just snug against the clevis pin.
(Shown in "Attach the Horizontal Mounting Bracket" on page 3.)
2
For regulatory compliance information, refer to Doc. 7475.
QUICKSTART DOC. 7245C (2032356, Sheet 1 of 2)
Cable Retractors for FlipTops™
Typical Assembly (Horizontal Orientation)
Cable End
Retraction
Lever
VERT
HORZ
Typical Assembly (Vertical Orientation)
Knob
SLOW
FAST
www.crestron.com
02.14
Specifications subject to
change without notice.
Mounting
Bracket
Assembly
Clevis Pin
Hairpin
Cotter Pin
Retractor 'A'
Retractor 'B'
2-Wire Spacer
Blank Spacer
Mounting Bracket
Assembly
Clevis Pin
Hairpin
Cotter Pin
Retractor 'A'
Retractor 'B'
2-Wire Spacer
Blank Spacer
888.273.7876
201.767.3400
Attach Cable Retractors to the FlipTop (FlipTop 600 Series)
1.
Insert the necks of the retractors into the FlipTop until they engage
the frame of the assembly.
2.
Insert the shoulder screws in the front of the FlipTop.
3.
Tighten each individual set screw on the retractors.
Attach the Cable Retractors (FlipTop 600 Series)
Shoulder Screws