Fibercommand ULTRAVISION Dépannage - Page 4

Parcourez en ligne ou téléchargez le pdf Dépannage pour {nom_de_la_catégorie} Fibercommand ULTRAVISION. Fibercommand ULTRAVISION 5 pages.

9) If you see the same 5 LIGHTS on the other side of the cable, this means the HDMI is

transmitting correctly through the cable. Skip to STEP #10

IF OTHERWISE you see less or none of the 5 Lights on the other side of the cable it

means the cable has been broken, so you should contact our tech support providing all

your test pictures for further help.

These cables contains ARMORED KEVLAR ( yellow color fabric ) so it can be pulled

through walls or conduits with no issues.

The cause for a broken cable may include:

a. the cable has been pulled not using the Kevlar so connectors has been ripped off

inside

b. The cable has been pulled through a metallic conduit with sharp corners which

"cut" the cable as a knife

c. The cable has been pulled with "brute force" through a crowded conduit with no

space to pass, so it broke

d. The cable has been pulled with "brute force" while stuck somewhere along the

way, so it broke

e. The cable has been used as fish tape to pull many other cables.

Please note our KEVLAR fabric is to pull our cable only.

These are few of the most common factors that could brake not only our cable

but any cable, and our warranty cannot cover these damages.

Please contact us to find the best solution to help you.

10) Connect the DISPLAY HDMI Plug to the cable, then connect our HDMI DISPLAY plug to the

TV or PROJECTOR HDMI input.

Make sure the TV or Projector is turned ON and selected to the proper HDMI input where the

cable is connected.

IMPORTANT: please plug the USB POWER PLUG of the DISPLAY HDMI PLUG SIDE to a

permanent usb 5 volts power you can get from the TV or the Projetor or from the

powerstrip or from a phone charger block. The power requires is 150 milliamperes so

any USB charging port will do with no issues.