Sharp 20MR10 Manuel d'entretien - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'entretien pour {nom_de_la_catégorie} Sharp 20MR10. Sharp 20MR10 26 pages. Service manual

INSTALLATION AND SERVICE INSTRUCTIONS

Note: (1) When performing any adjustments to resistor controls and transformers use non-metallic

screwdrivers or TV alignment tools.

(2) Before performing adjustments, the TV set must be on at least 15 minutes.

CIRCUIT PROTECTION

The receiver is protected by a 4.0A fuse (F701),

mounted on PWB-A, wired into one side of the AC

line input.

X-RADIATION PROTECT OR CIRCUIT TEST

After service has been performed on the horizontal

deflection system, high voltage system, B+ system,

test the X-Radiation protection circuit to ascertain

proper operation as follows:

1. Apply 120V AC using a variac transformer for

accurate input voltage.

2. Allow for warm up and adjust all customer controls

for normal picture and sound.

3. Receive a good local channel.

4. Connect a digital voltmeter to TP653 and make sure

that the voltmeter reads 21.4 ±1.5 V.

5. Apply external 27.2V DC at TP653 by using an

external DC supply, TV must be shut of f.

6. To reset the protector, unplug the AC cord and make

a short circuit between TP651 and TP652. Now make

sure that normal picture appears on the screen.

7. If the operation of the horizontal oscillator does not

stop in step 5, the circuit must be repaired before

the set is returned to the customer.

HIGH VOLTAGE CHECK

High voltage is not adjustable but must be checked

to verify that the receiver is operating within safe

and efficient design limitations as specified checks

should be as follows:

1. Connect an accurate high voltage meter between

ground and anode of picture tube.

2. Operate receiver for at least 15 minutes at 120V AC

line voltage, with a strong air signal or a properly

tuned in test signal.

3. Enter the service mode and select the service

adjustment "S03" and Bus data "01" (Y-mute on).

4. The voltage should be approximately 26.0kV (at zero

beam).

If a correct reading cannot be obtained, check

circuitry for malfunctioning components. After the

voltage test, make Y-mute off to the normal mode.

20MR10