DIGISYSTEM DSD-100 Manuel d'instruction - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} DIGISYSTEM DSD-100. DIGISYSTEM DSD-100 2 pages.
Imprimer la page
Circuit Diagram:
Caution:
Always disconnect the power cord before troubleshooting.
Trouble
Instrument inoperative
Fuse is burnt
Temperature can't be
controlled.
Instrument can't heat
DIGISYSTEM LABORATORY INSTRUMENTS INC.
Troubleshooting Guide
Cause
Power cord not connected to outlet.
Dead power output.
Fuse is burnt.
Electronic element broken
Power switch is broken
Voltage is not correct.
Heater is broken.
PC board is broken.
Temperature controller is broken.
Heater is broken.
PC board is broken.
Heater is broken.
PC board is broken.
Plug instrument in.
Change to different output.
Change a new fuse, and check if the voltage
is correct (refer to the back label).
Contact your distributor for repair.
Contact your distributor for repair.
Check and change to the correct voltage.
Contact your distributor for repair.
Contact your distributor for repair.
Contact your distributor for repair.
Contact your distributor for repair.
Contact your distributor for repair.
Contact your distributor for repair.
Contact your distributor for repair.
www.digisystemlab.com
Remedy
REV.3-2020