DIGISYSTEM DSO-DF Series Manuel d'instruction - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} DIGISYSTEM DSO-DF Series. DIGISYSTEM DSO-DF Series 3 pages. Hot air oven
Imprimer la page
5.2.3 You will see
value. Press
5.2.4 You will see
finished.
Remark: If you want to interrupt the timer mode, you can press
6. After finishing the work, please press "ON/OFF Button" to turn off the power, and then the "Power
indicator' becomes red.
Remark:
1. When the "OUT1" indicator on the display screen is sparkling, it means that the instrument is heating.
2. After the PV value reaches to SV value and tends to be stable, the "ALM1" indicator lamp will appear if the
PV value exceeds the SV value by setting point (10℃). In this situation, please turn the power off, open
the door and wait for about 30 minutes, and then restart it.
3. If you feel the PV value is much higher or lower than the SV value, you can adjust the "Air vent" on the
back of machine to balance the temperature. That is, if the PV value is too high, you can open the "Air
vent"; if the PV value is too low, you can close the "Air vent".
Maintenance and care:
Keep the machine clean all the time, so no routine maintenance is required. Cleaning can be done with a
damp cloth. Avoid the use of solvents as they may damage the product housing and inner chamber.
Circuit Diagram:
DIGISYSTEM LABORATORY INSTRUMENTS INC.
. Use
or
key to adjust the time value. Press
to next setting.
. Press
and you will see
www.digisystemlab.com
to enter the
. The setting is
to be continuous mode.
REV.1-2017