Sharp AR-5625 Manuel en ligne - Page 33

Parcourez en ligne ou téléchargez le pdf Manuel en ligne pour {nom_de_la_catégorie} Sharp AR-5625. Sharp AR-5625 36 pages. Ar-m250/m310/5600 series
Également pour Sharp AR-5625 : Manuel d'utilisation (4 pages)

Imprimer la page

TROUBLESHOOTING

If a Notice Page is printed

If you find that a notice page has been printed at the end of a print job, the print data received from the computer has not been

printed as specified. Fix the problem as explained below and then try printing again.

If a Notice Page is printed

If the following Notice Page is printed, check your settings for the Staple function.

☞

Stapling printed pages (when a finisher is installed)

****************************************************

Notice Page

****************************************************

The IMC memory full error had occurred,

a normal output was not able to be executed.

Please refer to the operation manual for

the solution method.

The IMC memory is used to store print data when the ROPM function is used. This memory is also used to store original image data

Note

in the copy mode. The percentage of IMC memory allocated to the printer function can be adjusted using a key operator program.

See "MEMORY FOR PRINTER" in the key operator's guide. The memory can be extended by adding commercially available

memory modules. For details, contact your SHARP dealer.

Disabling notice page printing

Notice page printing can be disabled using a key operator program (see "PROHIBIT NOTICE PAGE PRINTING" in the key operator's

guide).

C O N T E N T S

When the Staple function is not selected:

Disable the ROPM function by removing the checkmark from

"ROPM" in the "Configuration" tab of the printer driver setup

screen. (See "CONFIGURING THE PRINTER DRIVER" in the

software setup guide.) If you wish to use the ROPM function,

set the print quality to "Draft" or increase memory.

When the Staple function is selected:

Select "Draft" for the "Print quality" setting, or increase the

value set for "MEMORY FOR PRINTER" in the key operator

programs. If this does not solve the problem, add more IMC

memory.