Sharp AR-M237 IMAGERs Manuel de l'opérateur de la clé - Page 15
Parcourez en ligne ou téléchargez le pdf Manuel de l'opérateur de la clé pour {nom_de_la_catégorie} Sharp AR-M237 IMAGERs. Sharp AR-M237 IMAGERs 24 pages. Digital multifunctional imager
Également pour Sharp AR-M237 IMAGERs : Spécifications (2 pages), Manuel de configuration du logiciel (18 pages), Manuel de configuration du logiciel (20 pages), Manuel de référence rapide (39 pages), Manuel de référence rapide (39 pages)
Imprimer la page
OUTPUT TRAYS
(When the printer or fax function is enabled and a JOB
SEPARATOR TRAY KIT or FINISHER is installed)
This program is used to select the respective output
trays for the copy, printer, and fax functions.
The factory default setting is "PATTERN 1".
Example: When a FINISHER is installed
* Settings that can be selected vary depending on the
options that are installed.
Settings
PATTERN 1
PATTERN 2
PATTERN 3
(When the fax
function is enabled)
PATTERN 4
(When the fax
function is enabled)
OFFSET FUNCTION SETTING
This program is used to enable or disable the offset
functions of the center tray and offset tray (when a
FINISHER is installed).
This program is initially enabled (factory default
setting).
MEMORY FOR PRINTER
This program is used to set the amount of IMC
memory that is allocated to the printer function. The
amount of memory can be set from 30% to 70% in
increments of 10%.
The factory default settings are as follows:
• 50 (%)
• THE MEMORY AREA FOR PRINT HOLD: 30 (%)
G Memory allocated to print hold
(When the PRINTER EXPANSION KIT is installed)
To set the amount of memory allocated to print hold,
touch the [THE MEMORY AREA FOR PRINT
HOLD] key. The amount of memory can be set from
30% to 70% in increments of 10%. If 0% is selected,
the print hold function cannot be used.
DISABLING OF CENTER TRAY
COUNTING
This program is used to disable counting of pages
delivered to the center tray.
When this program is enabled, center tray full
detection does not take place.
This program is initially disabled (factory default
setting).
Description
Copy: Offset tray
Printer: Center tray
Fax: Top tray
Copy: Center tray
Printer: Offset tray
Fax: Top tray
Copy: Center tray
Printer: Offset tray
Fax: Center tray
Copy: Offset tray
Printer: Center tray
Fax: Center tray
RETURN FROM COPY MODE TIMING
(When the printer function or fax function is enabled)
This program is used to set the amount of time that
must elapse after a copy job is finished before the
printer or fax function resumes operation. The amount
of time can be set from 1 second to 60 seconds in
increments of 1 second.
The factory default setting is "60" (sec.).
MIX SIZE ORIGINAL FEEDING MODE
When this program is enabled, originals of mixed
length (the widths must be the same) can be scanned
in copy mode and each original copied onto the
corresponding length of paper.
This program is initially disabled (factory default
setting).
GENERAL PROGRAMS
13