Sharp AR-M316 Manuel d'utilisation - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Sharp AR-M316. Sharp AR-M316 4 pages. Digital multifunctional system key operator's guide
Également pour Sharp AR-M316 : Manuel en ligne (36 pages), Manuel de configuration (20 pages), Manuel d'utilisation (48 pages), Manuel de l'opérateur de la clé (24 pages)

ADDITION TO SPECIAL MODES

The following function has been added to the "SPECIAL MODES".

TRANSACTION REPORT PRINT SELECT SETTING

Transaction reports are printed based on conditions set in the system settings; however, you can

temporarily select different conditions for a transmission.

• The print conditions for a transaction report are as follows:

"PRINT OUT ALL REPORT":A transaction report is printed no matter whether the transmission

"NO PRINTED":Do not print a transaction report.

• When "PRINT OUT ALL REPORT" is selected, you can select whether or not part of the transmitted

fax image is included on the transaction report (select "PRINT OUT" or "NO PRINTED"). Note that

even when "PRINT OUT" is selected, part of the fax image will not be printed when speaker dialing,

direct transmission, polling reception, F-code transmission, or confidential transmission is used.

SYSTEM SETTINGS (Administrator)

The "System Settings (Administrator)" in the system settings are referred to as "Key Operator

Programs" in the Operation manual (for facsimile). For explanations of the system settings

(administrator) for the fax function, see chapter 8, "KEY OPERATOR PROGRAMS", in the Operation

manual (for facsimile).

At places in the Operation manual (for facsimile) that refer to the "Key Operator Programs", substitute

"System Settings (Administrator)".

Due to this change, steps 1 to 3 on pages 94 and 105 are as follows.

Press the [SYSTEM SETTINGS] key.

LINE

DATA

B STATUS

SYSTEM SETTINGS

Touch the [ADMINISTRATOR SETTINGS] key.

CONTRAST

ADDRESS

RECEIVE MODE

CONTROL

ADMINISTRATOR SETTINGS

Use the numeric keys to enter the five-digit administrator password.

ADMINISTRATOR PASSWORD

succeeds or fails.

Each time a digit is entered, the dash (-) that indicates the digit will

change to an asterisk (*).

The factory default setting for the administrator password is

00000.

For the steps that follow, see pages 94 and

105 of the Operation manual (for facsimile).

PRINTED IN CHINA

2009G

KS1

TINSE2035QSZZ