Problem
Smudges appear on
printed output.
Toner does not adhere
well or creases appear
in the paper.
Print quality is poor.
Part of the image is
cut off.
Printing takes place
on the wrong side of
the paper.
32
Point to check
Are you printing on pre-punched paper?
Does a message appear indicating the
need for maintenance?
Are you using paper that is not within
the specifications?
Did you set the correct paper type?
Is the paper loaded so that printing
takes place on the reverse side?
Is toner save mode enabled?
Has the correct paper size been set?
Was the original placed in the correct
position?
Is the paper loaded with the print side
facing in the correct direction?
Solution
If the printed image overlaps the punch holes, smudges
may appear on the reverse side of the paper following
one-sided printing, or on both sides following two-sided
printing. Take care that the image does not overlap the
punch holes.
Contact your dealer or nearest authorised service
representative as soon as possible.
Use SHARP-recommended paper. Using paper that is
for other models or special paper that is not supported
may result in misfeeds, creases, or smudges.
☞
"SUPPLIES" in the Safety Guide
Set the correct paper type in the tray settings. Make
sure that the following has not occurred:
• Heavy paper is being used, but a paper type other
than heavy paper is selected in the tray settings. (The
image may disappear if rubbed.)
• Paper other than heavy paper is being used, but
heavy paper is selected in the tray settings. (This may
cause creases and misfeeds.)
➞ System Settings > "Paper Tray Settings" > "Tray
Settings"
If printing takes place on the wrong side of label sheets
or transparency film, the toner may not adhere well and
a clear image may not be obtained.
When "Toner Save in Printer Mode" or "Toner Save in
Copy Mode" mode is enabled, printing takes place using
less toner and thus the print result is lighter. Check with
your administrator.
If you are using a special size, be sure to specify the
paper size.
If the size of paper loaded in a tray was changed, be
sure to check the paper size setting.
➞ System Settings > "Paper Tray Settings" > "Tray
Settings"
If you are using the document glass, be sure to place
the original in the far left corner of the document glass.
☞
Illustration of the machine (I) (page 37)
• Paper tray: Load the paper with the front side facing
up. (Load "Pre-Printed" paper and "Letter
Head" paper with the front side facing
down*.)
• Bypass tray: Load the paper with the front side facing
down.
* If "Disabling of Duplex" is enabled in the system
settings (administrator), load the paper front side up.
For the current setting, check with your administrator.
Imprimer la page