Sharp X-M200DK Manuel d'installation - Page 24

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Sharp X-M200DK. Sharp X-M200DK 38 pages. Digital multifunctional system

Imprimer la page

[10] ADJUSTMENTS

1.Simulations

A. Entering the simulation mode

Simulation is hereinafter described as SIM.

Perform the following procedure to enter the SIM mode.

"#" key

Interrupt key

"C" key

Start key

Sub code

Start key

B. Canceling the SIM mode

When the clear all key is pressed, the SIM mode is cancelled.

When the interruption key is pressed, the process is interrupted and the

screen returns to the sub code entering display.

After canceling the SIM mode, be sure to turn OFF/ON the power

and check the operation.

Note:If the machine is terminated by a jam error or paper empty during

copying in the adjustment by the SIM, recopying is required.

Interrupt key

Main code

ADJUSTMENTS 10 - 1

2.Copier adjustment

A.Mechanism section

Note: If a jam error or paper empty occurs during copying in the

adjustment by the simulation, the image data are not saved, and

therefore recopying is required.

(1) Image position adjustment

a.OC image lead edge position adjustment (SIM 50-1)

Note:In advance to this adjustment, the sub scanning magnification ratio

adjustment must be performed.

1) Set a scale on the OC table as shown below.

2) Make a copy.

3) Check the copy output. If necessary, perform the following

adjustment procedures.

4) Execute SIM 50-1.

5) Set the OC lead edge position set value (PHOTO indicator ON) to [1]

The OC image scanning start position is shifted inside the document

edge.

6) Set the 1st tray lead edge void adjustment value (TEXT indicator

ON) * to [1]

The lead edge void becomes the minimum.

7) Set the 1st tray print start position value (AUTO, 1st tray indicator

ON) to [1] and make a copy.

The print start position is shifted inside the document edge.

*The dimension varies depending on the model.

8) Measure the image loss R of the copied image. Enter the set value

of the image scanning lead edge position (PHOTO indicator ON)

again.

•1 step of the set value corresponds to about 0.1mm shift.

•Calculate the set value from the formula below.

R/0.1(mm) = Image loss set value

<R: Image loss measurement value (mm)>

* The scanning edge is set.

(A line may be printed by scanning the document edge.)

Example:

4/0.1 = 40 = about 40

Note:If the set value is not obtained from the above formula, perform the

fine adjustment.

5mm

4mm

5mm

0mm