Crestron CLS-SLVSW Manuel de l'utilisateur - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Crestron CLS-SLVSW. Crestron CLS-SLVSW 6 pages. Stand-alone wall box switch

Imprimer la page

CLW-SW, SWS, & SLVS(W/A/B)

Physical Description

The -SW and -SWS switch contains two buttons (one

large, one small), a light emitting diode (LED), and a

three-position slider-switch as shown after this paragraph.

Line voltage connections are made at the rear of the

switch. Three Class 2 low voltage wires, located on the

front of the switch, provide a Cresnet connection to a

control system. The wires can be routed to the bottom of

the unit for placement outside of the wall box. The -SLVS

is similar to the -SW and -SWS but does not have the

slider-switch or the Class 2 low voltage wires.

CLW-SW/SWS shown in white

Physical view of CLW-SW/SWS (clockwise from top; Top,

Side, and Front)

2 • Stand Alone Wall Box Switch : CLW-SW, SWS, & SLVS

Physical view of CLW-SLVS (clockwise from top; Top, Side,

and Front)

The -SW, -SWS, and -SLVS mount in a standard wallbox

and are covered using a decorative faceplate (not

included).

Industry Compliance

This product is Listed to applicable UL Standards and

requirements by Underwriters Laboratories Inc.

Important Notes

Read before installation.

•

Codes: Install in accordance with all local and

national electrical codes.

Alternate wiring methods may be used for the

Class 2 wiring connection. The 2002 National

Electrical Code (Article 725-55) prohibits Class

2 conductors of the -SW, -SWS, and -SLVS to

occupy the same outlet box as the power

conductors. The exception is Part D of Section

725.55 of the 2002 National Electrical Code,

which allows a device's power conductors to be

installed near (0.25 inch minimum spacing)

associated Class 2 conductors in the same outlet

box. Consult the 2002 National Electrical Code

Handbook and your local electrical inspector

before proceeding.

Do not use the supplied butt-splice connectors if

Installation Guide – DOC. 6134B