Digital Acoustics IP7-SE8 Manuel de démarrage - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage pour {nom_de_la_catégorie} Digital Acoustics IP7-SE8. Digital Acoustics IP7-SE8 4 pages. Ip intercom/paging
Également pour Digital Acoustics IP7-SE8 : Manuel de démarrage (16 pages)

Imprimer la page

IP7-SE8 Wiring (2-way Intercom/Paging mode)

(No Connection)

18-20 AWG Twisted Shielded

18 AWG - Max 200'/60M

Relay Output (Optional)

Sensor Input (Optional)

Microphone

No Connection

IP7-SE8 Installation (Paging Mode Only, 8 Ohm Speaker)

• Connect SPKR 8Ω+ and SPKR 8Ω- (J2-6 and J2-7) to the terminals of an

8 Ohm speaker (polarity independent)

18 AWG - Max 200'/60M

12VDC

(Optional)

Cat-5/6 to

PoE Switch

Speaker

Talk Button

Cat-5/6 Cable

to PoE Switch

Relay Options

• The integrated Relay uses COMMON (J3-2), along with NO - Normally

Open (J3-1) or NC - Normally Closed (J3-3). Use Admin Console to

configure the options

Sensor Options

• The integrated Sensor can be used to monitor the status of a door by

connecting Sensor (J3-5) and GND (J3-6) to a contact closure sense

switch. Use Admin Console to configure the options

Power Options

• Power over Ethernet (PoE - 802.3af compliant) - requires 15.4 Watts from

Power Source Equipment (PSE)

• 12VDC at 15 watts via J1-1 and J1-2 connectors (polarity independent)

• 12VDC at 15 watts via the Aux Power 2.1mm barrel connector

• An external power supply, if detected, overrides PoE power

Network Installation

• Connect an RJ-45 cable between the Ethernet 10/100 connector and a

network switch

• After the Ethernet 10/100 is connected, another IP device can be

connected to Port 2 10/100 jack

Mounting Instructions

The IP7 series is design to be mounted on standard 35mm DIN rail or

surface mounted using the surface mounting plate.

• DIN Rail Clip – Tilt top of unit (J1, J2, J3 connectors facing up with Volume

buttons facing forward) back towards the DIN Rail until the IP7 DIN clip

catches the top of the rail. Press in at the bottom of the IP7 to snap into

place

• Surface Mount Plate – Snap the surface mount plate in half and secure it

to the back of the unit using the provided screws so that the mounting

holes extend past the edges of the case

Page 2 of 4