Sharp Notevision PG-D40W3D Manuel de configuration - Page 11
Parcourez en ligne ou téléchargez le pdf Manuel de configuration pour {nom_de_la_catégorie} Sharp Notevision PG-D40W3D. Sharp Notevision PG-D40W3D 35 pages. True xga/wxga data projectors
Également pour Sharp Notevision PG-D40W3D : Manuel de l'utilisateur (2 pages), Fiche technique (2 pages), Spécifications (2 pages), Brochure & Specs (2 pages)
Imprimer la page
1. Connecting the Projector
to a Computer
Establishing a one-to-one connection from
the projector to a computer. Using a
commercially available LAN cable (UTP
cable, Category 5, cross-over type) you can
confi gure the projector via the computer.
1
1
Disconnect the computer's LAN
cable from the existing network.
2
2
Connect a commercially available
LAN cable (UTP cable, Category 5,
cross-over type) to the projector's
LAN terminal and connect the
other end of the cable to the
computer's LAN terminal.
3
3
Plug the power cord into the AC
socket of the projector.
4
4
Turn on the computer.
Info
Confi rm that the LINK LED on the rear of the
projector illuminates. If the LINK LED does not
illuminate, check the following:
•
The LAN cable is properly connected.
•
The power switches of both the projector and
the computer are on.
This completes the connection. Now proceed to "2. Setting an IP Address for the Computer".
Setting up the Projector Network Environment
(cross-over type, commercially available)
(cross-over type, commercially available)
A LAN cable being
A LAN cable being
connected to the network
connected to the network
LAN cable
LAN cable
ON
ON
-11