Sharp Notevision PG-D40W3D Manuel de configuration - Page 21
Parcourez en ligne ou téléchargez le pdf Manuel de configuration pour {nom_de_la_catégorie} Sharp Notevision PG-D40W3D. Sharp Notevision PG-D40W3D 35 pages. True xga/wxga data projectors
Également pour Sharp Notevision PG-D40W3D : Manuel de l'utilisateur (2 pages), Fiche technique (2 pages), Spécifications (2 pages), Brochure & Specs (2 pages)
Imprimer la page
Setting up the Projector Using RS-232C or Telnet
Connect the projector to a computer using RS-232C or Telnet, and open the SETUP
MENU on the computer to carry out various settings for the projector.
When Connecting Using
RS-232C
1
1
Launch general purpose terminal
emulator.
2
2
Input settings for the RS-232C
port of the terminal emulator as
follows.
Baud Rate
: 9600 bps*
Data Length : 8 bit
Parity Bit
: None
Stop Bit
: 1 bit
Flow Control : None
* This is the factory default setting. If the value
of Baud Rate for the projector has been
changed, set Baud Rate here according to
the changed value on the projector.
3
3
Input "PJS11234" and press the
"Enter" key.
4
4
"OK" is displayed. Input
"PJS25678" and press the "Enter"
key within 10 seconds.
5
5
"User Name:" is displayed. Input
the user name and press the
"Enter" key.
•
If a user name has not yet been set, just
press the "Enter" key.
6
6
"Password:" is displayed. Input
the password and press the
"Enter" key.
•
If a password has not yet been set, just press
the "Enter" key.
7
7
Input "setup" and press the
"Enter" key.
•
SETUP MENU will be displayed.
▼SETUP MENU
-----------------------------SETUP MENU----------------------------
[1]IP Address
[2]Subnet Mask
[4]User Name
[5]Password
[6]RS-232C Baud Rate [7]Projector Name [8]DHCP Client
[A]Advanced Setup
[V]View All Setting
[S]Save & Quit
setup>
Note
•
User name and password are not set in the
factory default settings.
•
If the user name or password is entered
incorrectly three times, SETUP MENU will be
quit.
[3]Default Gateway
[D]Disconnect All
[Q]Quit Unchanged
-21