Digital Antenna PowerMax DA4KSBR-50U Manuel d'installation et d'utilisation - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} Digital Antenna PowerMax DA4KSBR-50U. Digital Antenna PowerMax DA4KSBR-50U 14 pages. 60 db gain dual band wireless amplifier/repeater system

Imprimer la page

To plug into a standard 110 VAC receptacle use P/N DP255, a 110 VAC to 5VDC Power

Supply. For use on a boat or RV, plug P/N DP515, a 12 VDC to 5 VDC Power Cable,

into a 12 VDC cigarette style power receptacle.

d. AMPLIFIER/REPEATER STATUS

The DA4000SBR unit is designed with a status/fault indicator to indicate proper unit

functionality. The chart below details the different LED color indicators.

LED

Picture

Green solid light

Picture

Yellow/orange

flickering light

Picture

Solid Red light

Picture

No light

Green light – shows normal Status and DA4000SBR is operating normally. No

corrective action necessary.

Green/yellow/orange flickering light - shows that cellular activity is being transmitted

through the DA4000SBR unit. The light will remain green with low levels of cellular

transmission and change to flickering yellow/orange as transmission increases. The light

may remain green with low levels of transmission.

Solid Red light – indicates a fault. Turn OFF power switch and proceed with the

following corrective actions:

• The red light indicates that the inside and outside antennas are located too close to

each other and need to be re-located. A typical installation requires that the inside

and outside antennas have a minimum separation distance of 40 feet and be

separated by an exterior wall. If the inside and outside antennas are not 40 feet

apart or more, relocate the antennas.

• If the outside and inside antennas are separated by 40' or more and an exterior

wall. The red light also indicates the use of analog phones.

No light – indicates missing power to the DA4000SBR unit. Proceed with the following

corrective actions:

• Verify that the power switch on the DA4000SBR unit is in the ON position.

• Test for 5VDC power – verify that 5VDC is available on the output plug of P/N

DP255 or DP515. If 5VDC is verified, the DA4000SBR unit may be defective.

See below

o Test for AC line voltage on the input plug of P/N DP255, 100 to 240VAC

to 5VDC Power Supply. If AC voltage is available and there is no 5VDC

on the output plug. The power supply is defective. See below

o Test for DC line voltage on the input plug of P/N DP515, 12 VDC to 5

VDC Power Cable. If input voltage is available and there is no 5VDC on

the output plug. The power cable is defective. See below

• DA4000SBR unit, DP255 or DP515 may be defective. Contact your dealer. The

serial number on the DA4000SBR unit must be available.

Amplifier/Repeater Status

Normal Status

Degree of cellular transmission activity

Fault needs immediate corrective action

No power to the DA4000SBR

amplifier/repeater or unit is defective