Crestron 3 Series Manuel de démarrage rapide - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Crestron 3 Series. Crestron 3 Series 6 pages. Automated processors
Également pour Crestron 3 Series : Manuel de démarrage rapide (2 pages), Démarrage rapide (2 pages), Extrait du manuel (2 pages), Extrait du manuel (2 pages), Manuel rapide (2 pages), Manuel de démarrage rapide (2 pages), Manuel de démarrage rapide (8 pages), Manuel d'utilisation (20 pages)

RMC3

3-Series® Room Media Controller

COM 1 Connections

Port

RS-232

GND

TX (from RMC3)

TX- (from RMC3)

RX (to RMC3)

RX+ (from RMC3)

RTS

RTS (from RMC3)

TX+ (from RMC3)

CTS

CTS (to RMC3)

RX- (to RMC3)

1. RS-422 transmit and receive are balanced signals that require two lines plus a ground

in each direction. RXD+ and TXD+ should idle high (going low at start of data

transmission). RXD- and TXD- should idle low (going high at start of data

transmission). If necessary, RXD+/RXD- and TXD+/TXD- may be swapped to maintain

correct signal levels.

2. A ground terminal connection is recommended but not required.

Configure the Device

The RMC3 may be configured using Crestron Toolbox™ software or the

included web-based configuration utility.

To configure the control system:

1. Use the Device Discovery tool in Crestron Toolbox to discover the

RMC3 and its IP address on the network.

2. Use Crestron Toolbox to set the time zone. For more information,

refer to the Crestron Toolbox help file.

RS-422

RS-485

GND

TX-/RX-

Not used

TX+/RX+

Not used

3. Use a web browser to navigate to http:// xxx.xxx.xxx.xxx /setup, where

xxx.xxx.xxx.xxx is the device IP address. The 3-Series splash page is

displayed.

NOTE:

If a security warning is displayed, click Install to continue.

Quick Start