Shimano BR-M6000 Manuel du distributeur - Page 21
Parcourez en ligne ou téléchargez le pdf Manuel du distributeur pour {nom_de_la_catégorie} Shimano BR-M6000. Shimano BR-M6000 39 pages. Hydraulic disc brake
Également pour Shimano BR-M6000 : Manuel du distributeur (39 pages)
Imprimer la page
- 1. Table of Contents
- 1. Important Notice
- 2. To Ensure Safety
- 3. List of Tools to be Used
- 4. Installation
- 4. Disc Brake Mount Adapter (for 180Mm Disc Brake Rotors)
- 4. Disc Brake Rotor Adapter
- 4. Brake Hose
- 5. Maintenance
- 5. Adding Shimano Genuine Mineral Oil and Bleeding Air
- 5. Replacing the Brake Hose
- 5. Replacing the Brake Pads
MAINTENANCE
Adding Shimano genuine mineral oil and bleeding air
8
If the brake lever is then operated, air bubbles in the system will rise up through the port
into the oil funnel.
Once the bubbles stop appearing, depress the brake lever as far as it will go.
It is normal for the lever to be stiff at this point.
9
Lever operation
To be continued on next page
With the brake lever depressed, open
and close the bleed nipple in rapid
succession (for approximately 0.5 seconds
each time) to release any air bubbles
which may be in the calipers.
Repeat this procedure about 2 to 3
times.
(A)
Then tighten the bleed nipple.
(x)
(y)
21
(A)
7mm socket wrench
Tightening torque
(x)
Loose
(y)
Slightly stiff
(z)
Stiff
NOTE
If the lever does not become stiff, repeat the
procedures from step 5.
(z)
4 - 6 N·m