Shimano STEPS E6000 Manuel de l'utilisateur - Page 23
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Shimano STEPS E6000. Shimano STEPS E6000 46 pages. Shimano steps e6000 battery and charger
Imprimer la page
3.10
Wheel
3.10.1 Changing the wheel
3.10.1.1 Wheel with axle nuts*
Removing the rear wheel
1. Remove the pedelec battery.
2. Change the gear to the one recommended by the gear manufacturer for
disassembly.
3. Remove the gear shift cable from the rear wheel.
4. Undo the axle nuts using a 15 mm spanner, turning anticlockwise.
5. Take off the chain.
6. Remove the rear wheel.
Replacing the rear wheel
1. Attach the chain.
2. Insert the rear wheel centrally in the drop-outs as far as it will go.
3. Re-attach the gear shift cable.
4. If necessary, fasten the brake anchor.
5. Tighten the axle nuts using a 15 mm spanner, turning clockwise.
6. Reinsert the battery.
*dependent on model
3.10.2 Quick-release wheels
DANGER
Front wheel: The quick-release skewer must be
wrong
positioned on the opposite side to the brake disc
(where fitted). If the quick-release skewer is on
the same side as the brake disc, there is a risk
that they can clash and lock the front wheel (see
diagram), which can cause a serious accident.
Quick-release skewer and
brake disk collide
All quick-release systems must be correctly tightened before you set off.
Otherwise the components can loosen – if that happens while riding you
could fall off, resulting in serious injuries.
Removing the front wheel
1. Remove the pedelec battery.
2. Open the axle lever by folding it by
180˚. You will now usually be able to
see the word 'OPEN' on the inside of
the lever.
3. Undo the adjustment nut by turning it
slightly anticlockwise.
Original User Guide | Pedelec Shimano Steps E6000 Version 1
*
Adjustment nut
Quick-release skewer
For 2. Open the quick-release skewer
EN-23