Shimano SG-8C20 Manuel d'entretien - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel d'entretien pour {nom_de_la_catégorie} Shimano SG-8C20. Shimano SG-8C20 36 pages. Inter-8 coaster hub
Également pour Shimano SG-8C20 : Instruction de service technique (4 pages)
Imprimer la page
3.
1) Secure the cassette joint to the hub
with the cassette joint fixing ring.
When installing the cassette joint fixing
ring, align the yellow ● mark with the
yellow ● mark on the cassette joint
pulley.
Cassette joint fixing ring
Align the
yellow ●
marks to
install.
Cassette joint
pulley
3.
2) After installing the cassette joint fixing
ring, turn it 45º clockwise.
Turn 45º
Cassette joint
fixing ring
CJ-8S20
JAPAN
Fit the cassette joint bracket
securely.
Installation of the hub
to the frame
1.
Mount the chain on the sprocket, and
then set the hub axle into the fork ends.
Hub axle
2.
Place the non-turn washers onto the right
side and left side of the hub axle. At this
time, turn the cassette joint so that the
projecting parts of the non-turn washers
fit into the grooves of the fork ends. If
this is done, the cassette joint can be
installed so that it is almost parallel to the
chainstay.
Non-turn washer
(for left side)
Chainstay
Different types of left and right non-
turn washers are available for use with
standard and reversed fork ends. Use
CJ-8S20
JAPAN
whichever non-turn washers are suit-
able.
Fork end
5R/Yellow
Standard
Reversed
Reversed
(full chain
5R/Yellow
case)
R
7
The projecting parts should be on the
fork end side.
Install the non-turn washers so that the
projecting parts is securely in the fork
end grooves on either side of the hub
axle.
Fork end
3.
Take up the slack in the chain and secure
the wheel to the frame with the cap nuts.
Non-turn washer
Cassette joint
Groove of
fork end
Non-turn
washer (for
right side)
Non-turn washer
Mark/Color
Size
Right
Left
θ θ
5L/Brown
20º
º®
θ θ
7R/ Black
7L/Gray
38
θ θ = 0
6R/Silver
6L/White
θ θ = 0
5L/Brown
Mark
Tightening
torque:
30 – 45 N·m
{260 – 390 in. lbs.}
Cap nut
4.
Fix the brake arm securely to the chain-
stay with the brake arm clip.
Clip nut
Brake arm
Chainstay
NOTE:
• When installing the brake arm clip,
securely tighten the clip screw while
holding the clip nut with a 10 mm
spanner.
Tightening torque:
2 – 3 N·m {17 – 26 in. lbs.}
• After installing the brake arm clip,
check that the clip screw protrudes
about 2 – 3 mm from the surface of the
clip nut.
Brake arm
Brake arm clip
Clip nut
Clip screw
(M6 x 16 mm)
2 – 3 mm
5.
Before using the Coaster Brake, check
that the brake works properly and that
the wheel turns smoothly.
Clip screw
Brake arm clip
7