Crestron 4 Series Manuel de démarrage rapide - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Crestron 4 Series. Crestron 4 Series 12 pages. Control processor for zūm lighting control system
Également pour Crestron 4 Series : Manuel de démarrage rapide (8 pages), Manuel de démarrage rapide (8 pages), Manuel de démarrage rapide (6 pages), Manuel de démarrage rapide (6 pages), Démarrage rapide (5 pages), Manuel de démarrage rapide (6 pages), Manuel de démarrage rapide (2 pages), Manuel de démarrage rapide (2 pages), Pour commencer (2 pages), Manuel de démarrage rapide (2 pages)

ZUM-HUB4

4-Series™ Control Processor for Zūm® Lighting Control System

Installation

The ZUM-HUB4 can be mounted into a rack or placed onto a flat

surface.

Mounting Into a Rack

The hub occupies 1U of rack space.

To install the included rack ears:

1. Use a #1 or #2 Phillips screwdriver to remove the three screws from

each side of the front of the device as shown in the following

illustration.

2. Use the screwdriver and the screws removed in the previous step to

attach the included rack ears to the device.

3. Mount the device into the rack using four mounting screws

(not included).

Placing onto a Flat Surface

When placing the device onto a flat surface or stacking it with other

equipment, attach the included rubber feet near the corners on the

underside of the device.

The hub has a dedicated Control Subnet that is used for communication

between the control system and Crestron Ethernet devices. This subnet

allows for dedicated communication between the control system and

Crestron Ethernet devices without interferences from other network

traffic on the LAN.

Make the connections, and note the following:

Use Crestron power supplies for Crestron equipment.

The included cable(s) cannot be extended.

Apply power after all connections have been made.

NOTES:

Ensure the unit is properly grounded by connecting the chassis

ground lug to an earth ground (building steel).

The hub can be powered with the (included) 24VDC power pack.

Do not connect the CONTROL SUBNET port to the LAN. The

CONTROL SUBNET port must be connected only to Crestron

Ethernet devices.

For details on using the Control Subnet, refer to the

Systems Reference Guide

(Doc. 8559).

Quick Start

4-Series™ Control