Digital Barriers EDGEVIS HD-IP150 Manuel d'installation - Page 3
Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Digital Barriers EDGEVIS HD-IP150. Digital Barriers EDGEVIS HD-IP150 15 pages.
Imprimer la pageEDGEVIS HD-IP150 HARDWARE INSTALLATION GUIDE
SAFETY NOTES
The EdgeVis Encoder has been designed for use in indoor environments. It can operate in temperatures from 0˚C to
+55˚C whilst powered from 12V DC.
All deployments of an HD-IP150 encoder unit should ensure that the device is not mounted:
•
Within explosive zones
•
Within 0.5m of a powered transmitter and/or receiver antenna
•
Within the engine bay/compartment of a vehicle
•
Within 1m of a vehicle fuel fill point (direct line of sight)
WARNING: The HD-IP150 Encoder has been designed to operate from a 12V DC supply. Do not connect it directly
to mains power outlet. Use the AC/DC adapter supplied with the unit.
The following precautions must be taken to avoid damage to the unit:
•
DO NOT CONNECT DIRECTLY TO THE MAINS SUPPLY
•
Always ensure the supply is within the specified voltage range and employ
suitable filtering if voltage spikes are likely
•
Do not reverse the polarity of the DC power supply. It will cause irreparable
damage to the HD-IP150
•
Always provide a common ground between the HD-IP150 unit and all connected
equipment
WARNING: Failure to observe these precautions will invalidate the warranty.
ISSUED: 10 NOVEMBER 2020
PAGE 3