Accutone WT 89 Manuel d'installation et d'utilisation - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} Accutone WT 89. Accutone WT 89 8 pages. Wireless telephone headset

Imprimer la page

B. INSTALLING YOUR WT89 HEADSET

Installation

B1. connecting to the telephone

B2. connecting to the base station

Connect Power Adaptor (4) to the Power

Adaptor Jack (H), then connect to any power-

socket. (Make sure the voltage specified on the

adaptor corresponds to your local electrical

power supply specifications).

The Power Adaptor (4) comes with two types

of pin adaptors. Select the one that fit the

standard wall jack of your country, and simply

install the adaptor by facing the metal pins on

the power adaptor to the socket of the pin

adaptor. If you are un-sure about this, consult

with your local distributor for assistance.

putting everything together!

Unplug the handset from your telephone base,

and plug the handset into the Handset

Connector (J).

Connect one end of the RJ Modular Cable (X)

to the Telephone Connector (K) under the

base station, the other end of the RJ Modular

Cable (Y) goes into the handset jack of your

telephone unit (where it used to connect to the

telephone handset).

For instructions to connect to the handset lifter,

refer to P .12 of this manual.

B3. charging the wireless headset

Place the wireless headset into the base station

as illustrated. The illustration shows a right-ear

wearing setup. Refer to section C1 on how to

switch the headset wearing style from right-ear

to left. Both setup styles can be charged by

installing the headset into the base station.

Make sure the power adaptor is connected to

the unit and plugged into a power source.

The battery will be

fully-charged in 2 hours

and can operate for 5~8 hrs. The Battery

Charging Indicator (D) will light up red once

the headset is inserted to the base station.

When the power runs low, user will hear a warning signal through their

headset, and the Indicator (6) on the Headset will flash red as well.

Note that full battery capacity can only be achieved when the battery has been

charged and re-charged 4~5 times.

WT89 employs a special-designed system which prevents the battery from

being overcharged. However this also prevent users from replacing the

battery themselves. If you find that the battery runs out very quickly or that it

does not perform as we suggested here, please bring the unit back to your

local distributor for battery replacement. A fee may be charged on the battery

as well as the service provided.

To minimize risk of interference, the base unit should not be located close to other

electrical equipment, in direct sunlight or near any strong heat source. It is also normal

for the device to become warm during charging.

[ inspiring people, inspiring change ]

Installation