Digital Control DigiTrak Falcon F1 Manuel de démarrage rapide - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Digital Control DigiTrak Falcon F1. Digital Control DigiTrak Falcon F1 6 pages.
Imprimer la pageb.
Quick Scan Pair
Select
The screen displays the band and preset power modes and is ready to
pair. To learn more about interference and changing the preset power
modes, see the
Advanced Method: Scan, Pick, and Pair
At jobsites with challenging interference, use Frequency Optimization
(FO) to show the active interference (noise) as you walk the bore path.
The FO will show the previously saved and current noise level for band 11.
a.
With the Tx off, select
and then select
b.
Walk and scan the drill path to find areas with the highest noise levels.
c.
It is important to return to the point on the bore path with the highest
noise. Rescan
d.
You can do one of the following:
• To pair the newly optimized band, select
• To cancel and return to the Locating Mode screen without optimizing,
Cancel
select
The lower frequencies in band 11 will be less affected by rebar and passive
interference. To learn more, search the DCI DigiGuide App for "interference."
2. Pair the Locator with the Transmitter (Tx)
Tx's have two power levels:
deeper. Low power has faster data speed and longer battery life.
a.
Install transmitter (Tx) batteries and endcap.
b.
To change the power level, select
DCI DigiGuide App
search the
DCI DigiGuide App
Tx/FO
Scan
.
FO Results
to optimize band 11.
.
Standard
from the Main menu.
.
from the Main menu, select
1. Currently paired Down band
2. Band numbers
3. Maximum noise reading line
4. Down band (*Quick Select option)
5. Rescan
6. Pair
7. Exit/Cancel
Pair
Low
and
Tx Power Mode
for "power modes."
.
. Standard power operates
. To learn more,
- 2 -
FO
,