BitRage CR45-A-58 Manuel d'installation et de configuration - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel d'installation et de configuration pour {nom_de_la_catégorie} BitRage CR45-A-58. BitRage CR45-A-58 12 pages.
Imprimer la pageProduct Description
Connectors and Indicators
? Antenna connector
? Data In connector
? Data Out connector
? Power connector
? Numeric display
? RX LED
? TX LED
? Power display
1–4
The cable connectors and status indicators on the CR45-A are shown in
Figure 1-2 and described as follows:
[insert illustration here]
Figure 1-2. CR45-A Connectors and Indicators
Type N female 50 Ohm
Use up to 3.0 ft cable
BNC female 75 Ohm
Use RG 59 cable up to 900 feet
Note: Automatic Gain and Automatic EQ circuits are built-in
BNC female 75 Ohm
Use RG 59 cable up to 900 feet
Note: Automatic Gain and Automatic EQ circuits are built-in
4-pin female twist lock
2 pins are assigned to receive the DC operating voltage
2 pins are assigned to send the status data signal to the remote
monitoring unit
Used during the alignment process. Maximum value is displayed when
antenna is in the ideal position.
On when data is being received
On when data is being transmitted
On when DC operating power is present in the radio
xxxx, Ver 0.01