Digital Electronics FP790-T21 Manuel d'installation - Page 12
Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Digital Electronics FP790-T21. Digital Electronics FP790-T21 17 pages. Flat panel display
Imprimer la pageCreate a Panel Cut
Create a panel cut for the FP, according to the dimensions given here. Two addi-
tional items, the installation gasket and installation fasteners are also required when
installing the FP.
390.0
Attaching the Installation Fasteners
The FP-790 is equipped with 12 installation fastener holes (3 on each side). Use the
drawings below to locate the top and bottom face holes and use a Phillips screwdriver
to tighen each fastener.
Installation Fasteners
Top View
Panel
FP
• A torque of only 0.5 to 0.6 N•m is sufficient to tighten these
screws. Do not use too much force, since it may damage the
FP unit.
• If the dimensions of the Panel Cut are larger than those given
here, the panel can warp and distort the FP unit's display.
+0.5
+0.02
[15.35
]
0
0
4-R3 or less
Installation
Fastener
- 12 -
Installation Fasteners
Bottom View