Bits & Pieces RocketChip Manuel d'installation et d'utilisation - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} Bits & Pieces RocketChip. Bits & Pieces RocketChip 14 pages. Single chip accelerator
Imprimer la page******************************************************************
Warning
Turn
OFF
the
AC
power cord connected to the wall outlet and the computer.
Attempting to install
damage to your Apple computer and to
Inc. will not assume responsibility for damage caused by improper installation
or handling.
******************************************************************
3.1
Installation for the Apple II, II Plus, and IIe
RocketChip
MAKE SURE THAT THE COMPUTER POWER IS "OFF"
STEP #1: Removing the Apple II Cover
Grasp the back edge of the cover. Lift up on the cover until it releases
and then pull it straight back and lift it off. Set the cover aside.
STEP #2 : Removing Expansion Boards
The easiest way to gain access to the 6502/65C02 microprocessor is to
remove any optional expansion boards that you have installed in slots #2, #3,
#4, and #5. To remove an expansion board, carefully pull up on the board to
free it from the motherboard connector.
STEP #3 : Removing the 6502/65C02 Microprocessor and Installing Rocket
Important
Note
RocketChip can be damaged by static electricity, 6502/65C02, before touching
the 6502/65C02 or removing RocketChip from the anti—static protective package,
it is necessary for you to GROUND YOURSELF by touching the power supply
housing with your hand to remove any static electricity.
Touch
the
power
II, and II
is shown in Figure 1. The location of the 6502/65C02 for the
Plus
Apple IIe is shown in Figure 2. Use an IC chip puller tool or a small
flatbladed screwdriver to carefully remove the 6502/65C02 from the socket on
the motherboard. To avoid damaging the 6502/65C02, try to work the part
straight out of the socket so that pins do not get bent.
they can be carefully straightened with long nose pliers.
Touch
the
power
protective package. Look at either Figure 1 (II, II Plus) or Figure 2 (IIe)
and install Rocketchip in the motherboard socket as shown. Before pushing
fully into the socket, make sure that Pin #1 is oriented correctly
RocketChip
and that all 40 pins of the RocketChip are properly aligned in the socket and
that they are not bent.
power
switch
with the power applied can cause serious
RocketChip
for
you
to
read: Both your original microprocessor and
Supply
housing.
supply
housing.
on
your
Apple
RocketChip.
The location of the 6502 for the Apple
Remove
4
computer.
Leave
Bits
Pieces Technology,
&
pins do get bent,
If
the
Rocket
chip
the
AC
Chip.
from
the