Digital Electronics Corporation ST402-AG41-24V Manuel d'installation - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Digital Electronics Corporation ST402-AG41-24V. Digital Electronics Corporation ST402-AG41-24V 17 pages.

Connecting the ST Power Cord
When connecting the power cord, be sure to follow the procedures given below.
1. Confirm that the ST's power cord is unplugged from the power supply.
2. Remove the power plug from the ST unit.
3. Remove the vinyl cover of each of the power cord's wires and insert each wire
into the power plug's wire hole.
4. Replace the power plug.
• Use a flat screwdriver (Size 0.6 x 3.5) to tighten the terminal block wire set screws.
The torque required to tighten these screws is 0.5 to 0.6 N•m.
• Do not solder the wire itself.
Terminal block
wire set screws
E-14
Rear of ST
+
FG
-
Power Plug