Bittel HWDCD9888(38)TSD Manuel de l'utilisateur - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Bittel HWDCD9888(38)TSD. Bittel HWDCD9888(38)TSD 13 pages.
Imprimer la pageThank you for purchasing the NEW Bittel product.
Read following carefully before using this product
First, Battery Installation:
Before using this product, install the chargeable battery into the handset
( Named Handset for short) . Open the battery box which locates under the
back of phone , insert the battery into the right socket inside and put the
cover then fixing it with the screws attached. And plug with the rubber end
cap.
Then , charge the battery of handset :
After finish the first step, use the provided adaptor (9V/300mA) to charge
the battery through the RJ11adaptor . Don't forget to put the handset on the
right position on the base. The time for charging must last 8 hours for
normal use Also, please put the handset on the base to recharge after use it
for each time.
Last, matters need attention:
If the product out of power or long time does not use over 12 hours, please
unplug the battery from the socket to avoid any damage or shorten life for
this product. Must keep it use UPS for this wireless phone. If the handset
not install battery , must do not charge it.
When using this product, if the base or handset fail to work properly, please
re-plug the chargeable battery and power adaptor. Reset the system.
UNPACKING YOUR PHONE
This package should contain the following:
•
Base unit
•
Handset
•
Chargeable Battery
•
Fixing Screws and rubber end cap
•
Straight line cord 2 pieces (4-Pin )
•
This manual
•
Power adaptor
•
RJ11 connection box
_______________________________________________________________________
_BITTEL
Page 2 of 13
HWDCD9888(38)TSD