Epson WorkForce ST-C8000 Instructions - Page 2

Parcourez en ligne ou téléchargez le pdf Instructions pour {nom_de_la_catégorie} Epson WorkForce ST-C8000. Epson WorkForce ST-C8000 4 pages.

Imprimer la page

Insert the ink bottle into the filling port.

Do not force the bottles into position; they are keyed for

Note:

each color.

Wait for the bottle to empty. Do

not squeeze the bottle or allow

it to contact any other surface.

If ink does not flow from the

Note:

bottle, lift and reinsert the bottle.

When the ink bottle is empty, remove the ink

bottle and replace the bottle cap.

Do not leave the ink bottle inserted;

Note:

otherwise the bottle may be damaged or ink

may leak.

Close the black ink tank cap.

Repeat the previous steps for the other colors.

Close the ink tank cover.

Connect the power cord to the back of the product and to

an electrical outlet.

Do not connect to your computer yet.

Caution:

Raise the control panel, then press the

turn on the product.

If an error message appears, turn off the product and

Note:

check that no protective material has been left inside the product

and that the transportation lock is in the printing position.

Select your language, country, date, and time.

You can change these settings later using the product's

Note:

control panel. For more information, see the online User's Guide.

Follow steps 12 and 13 to continue ink charging.

When the message to see the Start Here sheet appears

on the LCD screen, press and hold OK for 5 seconds.

When the ink confirmation message appears on the LCD

screen, select Proceed for each color, then press Start to

start charging the ink. Ink charging takes approximately

9 minutes. A message appears when ink charging is

complete. Press Close to proceed with initial setup.

Part of the ink from the included bottles is used for printer

Note:

setup. You will notice ink levels in the tanks decrease during

charging. This decrease is normal and does not affect the stated

in-box yields.

Do not unplug or turn off the product, raise the

Caution:

scanner unit, or load paper while the product is charging or you'll

waste ink.

If there is ink remaining, repeat steps 1 through 8 to finish

filling the ink tanks. If any ink remains in the bottles, close

the bottles and store them for later use.

Replace the bottle cap before disposing of the bottles.

Note:

Select Settings > Maintenance > Ink Level Setting and

follow the on-screen instructions to reset the ink levels.

Load paper

See the online User's Guide for information about loading

capacity, available paper types and sizes, loading envelopes,

and using the rear paper feed slot or ADF.

Make sure the

product is not

charging ink, then

pull out a paper

cassette.

Slide the edge guides all the way out.

power button to