Siemens SIMATIC ET 200AL Manuel - Page 22

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Siemens SIMATIC ET 200AL. Siemens SIMATIC ET 200AL 32 pages. 10-link digital output module dq 8x24vdc/2a 8xm12
Également pour Siemens SIMATIC ET 200AL : Manuel (38 pages), Manuel (50 pages), Manuel (38 pages), Manuel (37 pages), Manuel de l'équipement (46 pages), Manuel (26 pages), Manuel de l'équipement (28 pages), Manuel de l'équipement (27 pages), Manuel (25 pages)

Imprimer la page

Mounting

Introduction

For the connection of the ET 200AL I/O module via ET-Connection to the ET 200SP, you

require the BaseUnit BU-Send with the BusAdapter BA-Send 1xFC.

Requirement

• The mounting rail is mounted.

• The interface module is mounted.

Required tools

3 to 3.5 mm screwdriver (only for dismantling the BusAdapter)

Mounting BaseUnit BU-Send

To mount the BaseUnit BU-Send, follow these steps:

1. Mount the BaseUnit BU-Send to the right of the CPU/interface module.

2. Swivel the BaseUnit back until you hear the mounting rail release latch into place.

3. Move the BaseUnit to the left until you hear it latch into place on the CPU/interface module.

Figure 5-1

4. Mount the BusAdapter BA-Send 1xFC only after you have connected the bus cable for ET-

Connection (see section Connecting).

Mixed configuration

Equipment Manual, 11/2020, A5E33344611-AD

Mounting BU-Send