Siemens simatic ET 200MP Manuel - Page 13

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Siemens simatic ET 200MP. Siemens simatic ET 200MP 45 pages. Digital output module dq 16x230vac/2a st relais (6es7522-5hh00-0ab0)
Également pour Siemens simatic ET 200MP : Manuel (40 pages), Manuel (24 pages), Manuel (29 pages), Manuel (47 pages), Manuel (26 pages), Manuel (28 pages), Manuel (50 pages), Manuel (34 pages), Manuel de l'utilisateur (44 pages), Manuel (30 pages), Manuel (25 pages), Manuel (42 pages), Manuel (28 pages), Manuel (33 pages), Manuel (49 pages), Manuel (36 pages), Manuel (39 pages), Manuel (28 pages), Manuel de l'équipement (35 pages), Manuel de l'équipement (32 pages), Manuel (29 pages), Manuel (34 pages), Manuel (36 pages), Manuel de l'équipement (50 pages)

Tip: Using the potential jumpers

Use the potential jumpers supplied with the front connector if you want to distribute the 24 V

DC supply voltage to a neighboring module. This helps you to avoid having to terminate two

wires to one terminal.

Proceed as follows:

1. Connect the 24 V DC supply voltage to terminals 19 and 20.

2. Insert the potential jumpers between terminals 19 and 39 (L+) and between terminals 20

and 40 (M).

3. Use the terminals 39 and 40 to loop the potential to the next module.

Figure 3-2

Note

Ensure that the maximum current load of 8 A per potential jumper is not exceeded.

Digital output module DQ 16x230VAC/2A ST Relay (6ES7522-5HH00-0AB0)

Manual, 03/2015, A5E34934019-AA

Using the potential jumpers

Wiring