Siemens SIMATIC ET 200SP Manuel de configuration - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel de configuration pour {nom_de_la_catégorie} Siemens SIMATIC ET 200SP. Siemens SIMATIC ET 200SP 20 pages. Distributed i/o system
Également pour Siemens SIMATIC ET 200SP : Manuel (40 pages), Manuel de l'utilisateur (21 pages), Manuel (34 pages), Manuel (48 pages), Manuel (30 pages), Manuel (34 pages), Informations sur le produit (38 pages), Manuel (37 pages), Manuel (36 pages), Manuel (44 pages), Manuel (31 pages), Manuel (35 pages), Manuel (23 pages), Manuel (34 pages), Manuel (29 pages), Manuel (33 pages), Manuel (31 pages), Manuel de l'utilisateur (32 pages), Manuel (31 pages), Manuel (28 pages), Manuel (41 pages), Manuel (32 pages), Manuel (49 pages), Manuel (24 pages), Manuel (34 pages), Manuel (41 pages), Manuel (30 pages), Manuel (31 pages), Manuel (27 pages), Manuel (24 pages), Manuel (24 pages), Manuel (25 pages), Manuel (49 pages), Manuel (40 pages), Manuel (38 pages), Manuel (39 pages), Informations sur le produit (24 pages), Manuel (32 pages), Informations sur le produit (10 pages), Manuel de l'équipement (43 pages), Manuel (33 pages), Manuel de l'équipement (44 pages), Mode d'emploi original (6 pages), Manuel (35 pages), Manuel (28 pages), Manuel de l'équipement (32 pages), Manuel (50 pages), Manuel (30 pages), Manuel (26 pages), Manuel (28 pages), Manuel (34 pages), Manuel (44 pages), Manuel (33 pages), Manuel de l'équipement (42 pages), Manuel d'instructions original (16 pages)

3 Configuration

4. Select the parameter group "Ethernet addresses" and, under "Interface

networked with", click "Add new subnet".

Figure 3-1

Result

The interface is now connected to a new subnet of the suitable subnet type. When

this is done, the address parameters of the interface are set consistently

automatically.

Then, add the interface module (here IM 155-6 PN ST) to the newly created

network.

Proceed as follows:

1. Open "Devices & Networks" in the overview.

2. Click on "Not assigned" in the interface module and select the IO controller

("PLC_1") to which this IO device is assigned to.

Figure 3-2

Result

The interface and the selected subnet are now connected. When this is done, the

address parameters of the interface are set consistently automatically.

SharedDeviceKonfig

Entry ID: 109741600,

V1.0,

11/2016