Siemens Simatic S7-1500 Manuel - Page 20

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Siemens Simatic S7-1500. Siemens Simatic S7-1500 50 pages. Digital output module dq 16x230vac/2a st relais (6es7522-5hh00-0ab0)
Également pour Siemens Simatic S7-1500 : Manuel (40 pages), Manuel (37 pages), Manuel (47 pages), Manuel (24 pages), Manuel (34 pages), Manuel de l'utilisateur (45 pages), Manuel (27 pages), Manuel de configuration (20 pages), Manuel (47 pages), Manuel (43 pages), Manuel (48 pages), Manuel (26 pages), Manuel (28 pages), Manuel (34 pages), Manuel de l'utilisateur (44 pages), Manuel (50 pages), Manuel (30 pages), Manuel (41 pages), Manuel (50 pages), Manuel (40 pages), Programmation de la sécurité Manualline (48 pages), Manuel d'instructions pour la communication (36 pages), Manuel (40 pages), Manuel (25 pages), Manuel (42 pages), Description de l'application (50 pages), Manuel (28 pages), Manuel (33 pages), Manuel (49 pages), Manuel (36 pages), Manuel (41 pages), Manuel (46 pages), Manuel (38 pages), Manuel (35 pages), Manuel (39 pages), Manuel (28 pages), Manuel (35 pages), Manuel de l'équipement (35 pages), Manuel (50 pages), Manuel de l'équipement (32 pages), Manuel de l'équipement (38 pages), Manuel (29 pages), Manuel de l'équipement (38 pages), Manuel (34 pages), Manuel (36 pages), Manuel de l'équipement (50 pages), Manuel (45 pages)

Parameters/address space

4.1 Parameter

Comparison value

With this parameter you specify the count value at which the digital output DQ (STS_DQ bit

of the feedback interface) switches due to the selected comparison event.

Start value

With this parameter, you specify the value at which counting begins and is continued if

defined events occur. The following condition must be met:

Low counting limit < = start value < = high counting limit.

Behavior when a counting limit is exceeded

With this parameter, you specify the behavior if a counting limit is exceeded.

Behavior

Stop counting

Continue counting

Meaning

After a counting limit is exceeded, the counting procedure is

aborted and the STS_GATE bit (internal gate) is reset.

To restart the counting, the SW_GATE bit must be reset via

the control interface and set again.

After a counting limit is exceeded, the counted value is set

to the other counting limit and counting is continued.

DI 32x24VDC HF digital input module (6ES7521-1BL00-0AB0)

Manual, 09/2016, A5E03485935-AF