Siemens Simatic S7-300 Manuel de l'utilisateur - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Siemens Simatic S7-300. Siemens Simatic S7-300 34 pages. Automation systems, controlling a physical axis
Également pour Siemens Simatic S7-300 : Manuel (21 pages), Mode d'emploi (4 pages), Mode d'emploi (5 pages), Manuel (35 pages), Pour commencer (8 pages), Pour commencer (16 pages), Description de l'application (24 pages), Manuel (18 pages), Manuel (32 pages), Manuel d'installation et de matériel (20 pages), Pour commencer (32 pages)

Click "Login" to enter the configuration interface.

You must firstly click"OK" to effect the revised parameters(parameters not saved at this time) after

you revise the parameters in every interface ,then finally click the "Apply Settings / Restart" to save

parameters and restart the ETH Adapter CN to work with the new parameters and then exit the

setting software. As shown below:

About the parameters configuration details, please read the "Device Manager Parameters

setting software manual".

After you configure the ETH Adapter CN parameters, you need to run VCOMM virtual serial port

software on the PC, simulate the ethernet interface of ETH Adapter CN as serial port (COM port)

on the PC, then choose this serial port in the local connection of STEP7 software ,like you use

the traditional PC Adapter.

Notice:The COM port of local connection in the "set PG/PC interface" menu of Siemens

programming software STEP7 can most support COM8, even though it can display above COM8,

in fact it can't use.

- 14 -