Siemens SINAMICS G120 Manuel d'utilisation - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Siemens SINAMICS G120. Siemens SINAMICS G120 32 pages. Using blocksize converters in marine applications
Également pour Siemens SINAMICS G120 : Pour commencer (46 pages), Pour commencer (30 pages), Instructions pour l'installation du matériel (2 pages), Instructions d'installation et manuel du propriétaire (2 pages), Instructions d'installation (2 pages), Instructions d'installation (2 pages), Mode d'emploi Compact (32 pages), Manuel (42 pages), Pour commencer (50 pages), Manuel de l'appareil (34 pages), Manuel d'installation rapide (2 pages), Description de l'application (50 pages), Mode d'emploi Compact (2 pages), Manuel (31 pages), Manuel d'application (34 pages), Mode d'emploi Compact (2 pages), Mode d'emploi Compact (2 pages)

Installing

3.4 Operator panels

The factory settings of the terminals for USS/CANopen and PROFIBUS/PROFINET

described above correspond to the following default settings:

● p0015 = 12 (setting in STARTER or Startdrive: "Standard I/O with analog setpoint")

● p0015 = 7 (setting in STARTER or Startdrive: "Fieldbus with data set switchover")

Further default settings can be found in the Operating Instructions:

Manuals for the Control Unit

(http://support.automation.siemens.com/WW/view/en/30563628/133300)

Wiring the terminal strip in compliance with EMC

1. If you use shielded cables, then you must connect the shield to the mounting plate of the

control cabinet or with the shield support of the inverter through a good electrical

connection and a large surface area.

Further information is provided in the Internet:

EMC installation guideline

(http://support.automation.siemens.com/WW/view/en/60612658)

2. Use the shield connection plate (order number 6SL3264-1EA00-0LA0) of the Control Unit

as strain relief.

3.4

Operator panels

Operator panel

An operator panel is used to commission, troubleshoot and control the inverter, as well as to

back up and transfer the inverter settings.

The Intelligent Operator Panel (IOP) is available for snapping on to the Control Unit or as

handheld with a connection cable to the Control Unit. The graphics-capable plain text display

of the IOP enables intuitive operation and diagnostics of the inverter.

The IOP is available in two versions:

● With European languages

● With Chinese, English and German

Additional information about the compatibility of the IOP and Control Units is available in the

Internet:

Compatibility of the IOP and Control Units

(http://support.automation.siemens.com/WW/view/en/67273266)

The BOP-2 is an operator panel for snapping on to the Control Unit. The BOP-2 has a two-

line display for operation and diagnostics of the inverter.

Operating Instructions of the BOP-2 and IOP operator panels:

Overview of the manuals (Page 29)

Compact Operating Instructions, 01/2016, A5E37058195B AA

CU250S-2 Control Units