Siemens SIPROTEC T103 Manuel - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Siemens SIPROTEC T103. Siemens SIPROTEC T103 38 pages.

Notes to SIPROTEC

objects

1.1

Annunciations

1.1.1

1.1.2

1.1.3

Note

The description of the standard mappings contains the pre-allocation of the mapping

files at delivery or first assignment of a mapping in DIGSI

vice.

Changes of the allocation and the scaling of the measured values are possible in ad-

aptation to the concrete installation environment (ref. to page 3).

Note

Depending on the device composition and the existing protection packages not all of

the indicated binary inputs or protection annunciations (and corresponding IEC

60870-5-103 Information numbers) may be available in the SIPROTEC

The "Error with a summary alarm" (Obj.- Adr. 140) is ON if at least one of the following

internal alarms assumes the value ON:

• "Error 5V", "Error 0V", "Error -5V", "Failure Battery empty", "Error Power Supply"

• "Error I/O Board", "Error Board 1", "Error Board 2", "Error Board 3", "Error Board 4",

"Error Board 5", "Error Board 6", "Error Board 7"

• "Error Offset", "Calibration data fault"

The "Alarm summary event" (Obj.- Adr. 160) is indicated, if at least one of the following

internal alarms assumes the ON status:

• "Failure Current Balance", "Failure Current Summation", "Voltage Balance"

• "Failure Phase Sequence Current", "Failure Phase Sequence Voltage"

The functionality "Stop data transmission" is not supported via IEC 60870-5-103 com-

munication. If "Stop data transmission" is active nevertheless data via IEC 60870-5-

103 will be transmitted furthermore.

4 to the SIPROTEC

device

7VU68x Redundant T103 Bus mapping

C53000-L2540-C558-1

de-