Cisco 522 Manuel - Page 8
Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Cisco 522. Cisco 522 24 pages. Ip phones with multiplatform firmware
Également pour Cisco 522 : Manuel de l'utilisateur (46 pages), Manuel (40 pages), Manuel d'administration (48 pages), Manuel d'installation (39 pages)
Imprimer la page
Standard Base for Cisco Headset 561 and 562
Standard Base for Cisco Headset 561 and 562
The Cisco Headset 561 and 562 come with a standard base to charge your headset. The base's LED display
shows the current battery level, and your call state. In addition to the call control buttons on the headset, you
can also answer and end calls when you lift or set down your headset on the base.
The connection between the base and the headset is made with Digital Enhanced Cordless Telecommunications
(DECT).
Figure 8: LED Display on the Standard Base for Cisco 561 and 562 Headset
The following table describes the standard base for Cisco 561 and 562 Headset.
Table 3: Standard Base for Cisco 561 and 562 Headset
Number
1
2
Cisco Headset 561 and 562 with Multibase
The multibase can connect up to three call sources through Bluetooth, the USB connector, or the Y-cable.
The multibase can save up to four Bluetooth devices. You can switch between call sources using the buttons
on the multibase. You use the call control buttons on the headset to answer and end calls. When your headset
is in the base, you automatically answer the call when you remove the headset from the base. You can return
the headset to the base to end the call.
The multibase comes with the following connector cables:
• USB to USB Cable: for Cisco IP Phones with USB connectivity
Accessories
8
Name
Battery Status LED
Call Status LED
Description
Indicates the headset battery charge.
Alerts you to the call state:
• Incoming call—Blinking green.
• Active call—Steady green.
• Muted call—Steady red.
Accessories