Epson 755c - PowerLite XGA LCD Projector Manuel des pièces détachées - Page 11

Imprimer la page

Epson 755c - PowerLite XGA LCD Projector Manuel des pièces détachées

Disabling the Projector's Buttons

When you enable the Operation Lock function, all the

projector's buttons are disabled except the P

This is useful, for example, if you want to prevent students in a

classroom from playing with the projector.

1. Press the

button.

2. Select the

menu and press

Setting

3. Select

and press

Operation Lock

4. Select

and press

Enter

to confirm the setting.

5. Press the

button to exit the menu system.

Note:

You can cancel Operation Lock by pressing the projector's

button for 7 seconds.

Presenting Over a Wireless Network

Using EMP NS Connection, you can project images shown on

your computer screen directly to your audience without

connecting the projector to your computer. Before you begin,

make sure you've installed EMP NS Connection from the

CD-ROM that came with your projector. See the User's Guide

for installation instructions.

Starting EasyMP

Before you can connect to the projector wirelessly, you have to

switch it to EasyMP mode.

1. Turn on the remote control and the projector.

2. Press the

button on the remote control to select

EasyMP

EasyMP as the source.

3. Insert the Epson 802.11g/b card in the projector's card slot.

Make sure the label side is facing up.

Note:

Only the Epson 802.11g/b card is guaranteed to work. Other

cards may not be compatible. Replacement cards are available

only through an Epson authorized servicer.

button.

Power

Enter

. Then select

and press

Yes

Enter

Epson PowerLite 755c/765c Projector

4. Once the card is inserted, you see one of these screens,

depending on the currently selected mode:

Enter

Access Point mode

5. If you've already configured the projector for your wireless

network, go to "Projecting Wirelessly" on page 15.

Otherwise, continue with the next section.

Configuring the Connection

You must configure both the projector and your computer's

network settings to project wirelessly.

You can configure the projector for either of the following

modes:

Ad hoc mode (computer to computer): Lets you connect just

one computer at a time; you need a computer with a wireless

(802.11g or 802.11b) network card or adapter, or a Macintosh

with an AirPort or AirPort Extreme card.

Access point mode (infrastructure): Lets multiple computers

access the projector, or trade off control of the projector; you

need a wireless (802.11g or 802.11b) access point or an AirPort

(or AirPort Extreme) base station, and one or more computers

with wireless network cards or adapters.

1. Switch the projector to EasyMP mode and insert the Epson

802.11 g/b card.

2. When you see the EasyMP screen, press the

the remote control to select

3. Use the

Wireless LAN

8/05

Config

pointer button to highlight

, then press

Enter

Epson PowerLite 755c/765c Projector

Ad Hoc mode

button on

Enter

under

Basic