Epson 821p - PowerLite XGA LCD Projector Informations sur le produit - Page 12

Parcourez en ligne ou téléchargez le pdf Informations sur le produit pour {nom_de_la_catégorie} Epson 821p - PowerLite XGA LCD Projector. Epson 821p - PowerLite XGA LCD Projector 15 pages. Release of emp ns connection for windows & mac upgrade from v2.50 to v2.51
Également pour Epson 821p - PowerLite XGA LCD Projector : Manuel de l'utilisateur (42 pages), Spécifications (2 pages), Manuel d'utilisation (47 pages), Liste des pièces (1 pages), Installation rapide (2 pages), Manuel de l'utilisateur (1 pages), Bulletin d'information sur les produits (25 pages), Bulletin d'information sur les produits (8 pages), Bulletin d'information sur les produits (22 pages), Bulletin d'information sur les produits (28 pages), Bulletin d'information sur les produits (41 pages), Bulletin d'information sur les produits (15 pages), Bulletin d'information sur les produits (22 pages)

Imprimer la page
Epson 821p - PowerLite XGA LCD Projector Informations sur le produit
Epson PowerLite 821p Projector
4. If you need to replace the filter, slide it off as shown.
5. Align the new filter carefully as you slide it in until it clicks
into place.

Replacing the Lamp

The projection lamp typically lasts for about 2000 hours of use
(in high brightness mode) or 3000 hours (in low brightness
mode). It is time to replace the lamp when:
❏ The projected image gets darker or starts to deteriorate.
❏ The
warning light is flashing orange.
❏ The message
Replace the Lamp
the lamp comes on. To maintain brightness and image
quality, replace the lamp as soon as possible.
Note:
You can check how many hours the lamp has been used in the Info
menu.
Turn the projector off when not in use. Continuous use may reduce
the overall life of the product.
Contact your dealer or call Epson at (800) 873-7766 in the
United States for a replacement lamp. Request part number
. In Canada, please call (800) 463-7766 to locate a
V13H010L30
dealer.
12
Epson PowerLite 821p Projector
-
appears on the screen when
Follow these steps to replace the lamp:
1. Press the P
Power
When you hear the projector beep twice, unplug the power
cord.
2. If the projector has been on, allow it to cool down for at least
half an hour (or until the lamp is cool).
Warning:
Let the lamp cool before replacing it. If the lamp breaks, handle
the shards carefully to avoid injury.
3. Use the screwdriver included with the replacement lamp to
loosen the screw holding the lamp cover (located on top of
the projector).
4. Slide the cover out, then lift it off.
5. Use the screwdriver to loosen the two screws holding the
lamp in place. (You can't remove the screws.)
6. Hold the lamp as shown and pull it straight out.
9/04
button twice to turn off the projector.
Loosen these
screws