Siemens Washing machine Manuel d'instruction et instructions d'installation - Page 20

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction et instructions d'installation pour {nom_de_la_catégorie} Siemens Washing machine. Siemens Washing machine 28 pages. Washing machine
Également pour Siemens Washing machine : Manuel d'installation et d'entretien (10 pages), Manuel d'utilisation (8 pages), Manuel d'instructions d'installation (6 pages), Instructions de référence rapide (2 pages), Instructions de référence rapide (2 pages), Instructions de référence rapide (2 pages), Manuel d'instruction et instructions d'installation (28 pages), Manuel d'instruction (28 pages), Manuel d'instructions d'installation (6 pages), Manuel d'utilisation (10 pages), Instructions de référence rapide (2 pages), Manuel d'instruction (10 pages), Manuel d'utilisation (28 pages), Manuel d'instruction (10 pages)

Imprimer la page
Siemens Washing machine Manuel d'instruction et instructions d'installation

Cleaning and care

Danger of electric shock!
Completely disconnect the washing
machine from the mains.
Never clean the washing machine with a
jet of water.
Danger of explosion!
Never use solvents for cleaning.
Danger of freezing
If there is danger of freezing, remove the
water-inlet hose from the tap and empty
the water from the drain hose and the
machine .

Cabinet

Use only soap and water.
Control panel, base, etc.:
Use only a moist towel.
Do not use:
• Scouring powder
• Metal pads or plastic sponges
• Alcohol-based products (alcohol, diluents,
etc.)
Interior components
It is suggested:
• To leave the lid open for some time after
washing.
• To clean the plastic and rubber parts of
the washtub inlet about once a month with
soapy water.Rinse thoroughly to remove
all traces of this cleaning material.
• It is suggested that the 90°C washing
programme be run at regular intervals.

Detergent dispenser

Clean the detergent dispenser regularly. For
this purpose:

Replacement of mains cable

Caution: For reasons of safety, it is essential that
the mains cable or, depending upon the model,
the entire electrical assembly along with the cable,
be replaced by the service department of the
manufacturer or a qualified specialist .
- To remove the detergent dispenser,
squeeze both pressure points
simultaneously ( Figure 10 ). The dispenser
then detaches itself from the chamber
(Figure 10) .
- Remove components
dispenser and separate from the front cover
(Figure 11) .
- Rinse the parts under running water.
Completely empty the dispenser.
- Reassemble all components in the proper order.
Snap the detergent chamber into place under
the lid of the washing machine.
Figure 10
Figure 11
20
at the rear of the