Cisco 7925G - Unified Wireless IP Phone VoIP Manuel d'installation - Page 18

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Cisco 7925G - Unified Wireless IP Phone VoIP. Cisco 7925G - Unified Wireless IP Phone VoIP 21 pages. Wavelink avalanche management console
Également pour Cisco 7925G - Unified Wireless IP Phone VoIP : Fiche technique (8 pages), Notes de mise à jour (16 pages), Manuel de l'utilisateur (28 pages), Manuel des accessoires (20 pages), Manuel des accessoires (13 pages), Manuel d'administration (19 pages), Manuel de l'utilisateur (10 pages), Manuel de l'utilisateur (16 pages), Manuel rapide (14 pages), Manuel d'administration (23 pages), Manuel d'administration (14 pages)

Active and Standby Phone Modes

The following sections describe the available modes when the Cisco Unified Wireless IP Phone is powered

on.

The phone is in active mode when there is an active RTP stream. When the phone is performing one of these

actions, it is consuming power:

• Connected to an active call

• Scanning for channels

• Sending CDP packets

• Sending keepalive messages

• Reregistering with Cisco Unified Communications Manager

The phone can enter standby mode if none of the events from the Active Mode list are currently active. The

phone awakes from standby mode in response to these events:

• Pressing keys on the keypad

• Roaming between APs

• Power cycling the phone

• Losing network connectivity

• Losing RF connectivity

• Transmitting scheduled CDP or keepalive packets

When connecting to the wireless VoIP network, the Cisco Unified Wireless IP Phone goes through a standard

startup process, as described in the following list. Depending on your specific network configuration, not all

of these steps may occur on your wireless IP phone.

Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide

Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Setup